Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.





Fast, Reliable Gate Repair Across Granada Hills
Gate repair in Granada Hills usually costs between $180 and $450 for hinge, post, and realignment work, while full operator replacements on long ranch driveways typically run $850 to $2,400. Most repairs in this area are completed in a single visit, often the same day you call, because we keep common parts for Granada Hills gates stocked on our trucks. If your gate post shifted in the 1994 earthquake and has been dragging ever since, that’s the kind of problem we have been correcting here for years. Call (350) 248-1180 and a live person answers, day or night.
Granada Hills poses a particular set of challenges for gate hardware. The San Fernando Valley interior heat bakes gate operators until thermal cutoffs trip. Santa Ana winds slam wide swing gates sideways until hinge bolts loosen. And under many of those gates, concrete footings cracked three decades ago and never settled back level. None of that is generic gate repair. It is Granada Hills gate repair, and the difference matters.
Why Ironworks Gate Co. Is Granada Hills’s Preferred Gate Repair Company
Victor Salinas leads a team that has spent years working driveways from Balboa Boulevard to the horse properties above Rinaldi Street. We know the difference between a motor problem and a post problem, and in Granada Hills that distinction is more important than almost anywhere else in the Valley. The 1994 Northridge earthquake epicenter sits just south of here, and decades later our Gate Repair technicians still find footings shifted, hinge posts out of plumb, and operators straining against geometry the manufacturer never anticipated.
Our Granada Hills customers call because the last contractor replaced a motor and walked away, and three months later the gate ground to a halt again. We do not do that. Every job ends with the 90-Day Done Right Promise in writing. If it is not right, we come back and make it right, no paperwork, no arguing. That promise applies to every hinge, every weld, every operator we touch in the 91344 and 91394 ZIP codes.
You will not reach a voicemail when you call us. A live person answers 24 hours a day, 7 days a week. For an emergency gate stuck open on a horse property or a sliding gate jammed across a shared driveway off San Fernando Mission Boulevard, that matters. We tell you when we will be there, and we are there when we say. Background-checked, uniformed technicians in your driveway, working the way they would work in their own mother’s home.
Our Gate Repair Services in Granada Hills
Electric Gate Repair
A gate opener that runs in the morning and quits by 2 p.m. is a Granada Hills signature. The Valley heat pushes 100 to 110 degrees in summer, and the interior of an operator housing runs hotter than that. Older LiftMaster and FAAC units on long ranch driveways trip their thermal cutoffs and refuse to reset until evening. We diagnose whether the motor is actually failing or simply working against a post that has been tilting since the quake. The fix is different, and only one of them lasts.

Automatic Gate Repair
On wide equestrian gates in the northern sections of Granada Hills, loop detectors occasionally fail to sense a vehicle and reverse while a horse trailer is still passing through. We test loops, re-tune sensitivity, and replace sensor components on eight other brands as needed. When a 20-foot tubular steel swing gate starts closing on your trailer, that is not a nuisance. It is a safety fault, and it gets corrected on the first visit whenever possible.

Hinge & Post Repair
Here is the truth about Granada Hills gate posts: many of them have been leaning for thirty years. The 1994 Northridge earthquake cracked concrete footings throughout this neighborhood, and the damage often did not show itself for a decade or more. A hinge post raked even three or four degrees out of plumb makes the gate bind, drag, and overload the operator. We re-set footings, true the post, and remount hinges so the gate swings clean without fighting itself.

Gate Realignment
Sliding gates on the 1950s through 1970s ranch properties along the main corridors take a beating. When the rack and pinion bind because the gate has sagged out of alignment, the motor pulls more amps and eventually burns out. We realign track, rack, and guide wheels, then verify the gate moves freely by hand before any operator is reconnected. A gate that runs smooth by hand runs easy under power, which is the whole point.

What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Granada Hills
Our technicians are trained and equipped on nine gate automation brands, and in Granada Hills we see a lot of three in particular. Viking opens many of the wide equestrian gates north of Rinaldi Street. DoorKing units still run on plenty of the original 1980s retrofits throughout the neighborhood. Ghost Controls operators are common on the newer, shorter driveway gates closer to Balboa. We keep common boards, limit switches, and remote receivers stocked for faster turnaround here, and because we service every major brand, the correct fix happens on the first visit instead of the third.
Common Gate Repair Problems We See in Granada Hills Homes
- The afternoon thermal cutoff trip. Summer temperatures in Granada Hills climb past 105 degrees, and operator housings soak up sun all day. A unit that trips its thermal protection at 3 p.m. and works fine at midnight needs either ventilation, relocation, or replacement, and we determine which one applies.
- The quake-shifted hinge post. A footing cracked in 1994 lets the post tip a few degrees over decades. The gate starts dragging on the latch side, the operator strains, and eventually the motor fails. Replacing the motor without fixing the post is the most common waste of money we see here.
- The Santa Ana wind loosening. Wind events funnel through the passes and hit wide swing gates with surprising lateral force. Hinge bolts loosen, the gate sags, and the latch stops catching. We re-torque and add thread-lock where appropriate, then re-check alignment.
- The horse-trailer gate overload. A 16 to 20 foot gate rated for horse-trailer traffic is far heavier than a standard residential operator can safely handle. When a builder installed a basic residential opener on an equestrian property in the northern part of Granada Hills, the motor has been overworked since day one. We replace it with a heavy-duty unit matched to the gate’s actual weight and cycle frequency.
Pricing for Gate Repair in Granada Hills, CA
Here are honest ranges for the work we do in Granada Hills. Hinge replacement and basic realignment on a standard single swing gate runs $180 to $320. Re-setting a shifted gate post footing and truing the post runs $420 to $850 depending on access and concrete work. A complete operator replacement on a 20-foot equestrian gate runs $1,400 to $2,400, while a basic residential opener swap runs $850 to $1,200. Slide gate track and rack repair runs $350 to $700. Every price is quoted and agreed before any work starts. No surprises on the bill. We offer a free second opinion on any written estimate, $50 off any repair over $250, an $89 seasonal tune-up, and a permanent 5% senior and veteran discount. Call (350) 248-1180 for a free estimate.
We Also Serve Cities Near Granada Hills
Our crews work throughout the surrounding San Fernando Valley from our Los Angeles office, serving Granada Hills and the neighboring communities of Northridge, Porter Ranch, San Fernando, and Sylmar. If you are just over the line from Granada Hills, the same team, same trucks, and same written guarantee cover your driveway too.
Serving Granada Hills, CA - Our Local Coverage Area
We’re based in the Granada Hills area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Repair in Granada Hills
Metal expands in heat, and a gate that clears the ground by a quarter inch in the morning can drag by late afternoon when Granada Hills temperatures top 100 degrees. But the usual cause is a post that has tilted out of plumb, and the drag just becomes visible under thermal expansion. Our crew checks post plumb before touching hinges. Call (350) 248-1180 and we will check yours.
No. A 20-foot tubular steel or wood gate rated for horse-trailer traffic weighs far more than a standard residential opener is designed to move, and the motor will fail early. We install heavy-duty operator models rated for the actual gate weight and cycle frequency. Replacing a burned-out residential unit with another residential unit is throwing money away.
It is common in Granada Hills, but it is not normal. Heat is the trigger, but the underlying cause is usually a gate that has become hard to move, which makes the motor pull more amps and generate more heat. We find the mechanical resistance first, then address heat management. Call (350) 248-1180 for a free estimate on diagnosing it properly.
Yes. Current safety standards require entrapment protection on automated gates, and any time we repair or replace an operator we verify the safety edges, photo eyes, and reverse function are working before we leave. A gate that closes on a person, a pet, or a horse trailer is a life-safety failure, not a convenience issue. We will not wire around a safety device to make a gate run.
Look at the gate post in relation to the fence line. If the post leans, or if the gap between gate and latch post is wider at the top than the bottom, the footing has likely shifted. A four-foot level against the post will show the lean. We see this constantly in Granada Hills, and the fix is re-setting the footing, not adjusting hinges. Call us and we will verify before recommending any repair.
Written by Victor Salinas, Owner at Ironworks Gate Co., serving Granada Hills with a live voice on the phone and a written guarantee on every job.
Before
After
Before
After
Before
After